Completed:
- Build 28'x12' shelter for work site on driveway.
- Re Soak transom with Rot Doctor's Clear Penetrating Epoxy Sealant (CPES).
- Use squeeze bottle with clear tubing to insert into crevasses above inner transom and saturate/fill into gaps etc.
- Remove top transom rub rail screws around splash well, drill and soak with CPES. Fill gaps with thickened epoxy. Install screws into epoxy.
- Use Rot Doctor's Epoxy Clean up Solvent (ECS), to clean up all over flow.
- Drill extra drain hole in belly tank compartment, soak/seal exposed wood with penetrating epoxy and install pvc tube with 5200.
- New stern jump seat cushions: Auto Trim Specialists, Denver, CO.
- Yorktown/Tan antiqued marine vinyl is a perfect match for this 35yr old boat.
- I cut and 1/2" and 3/4" birch wood panels, sealed with CPES.
- Install 40 gallon belly tank into compartment, new hoses.
- Remove 5/16" line from well to engine and install new 3/8" line and filter at motor.
- Install new 4 way brass fuel switch to well, connect to tanks and engine.
- Install new 14' of 1+1/2" ID Fuel Fill hose from below deck to fill port on Starboard bow.
- Drain tank, remove from below deck, clean out with manual swab on stick, remove fittings, install new fittings, reinstall tank below deck. Seal deck.
- Renovate Electronics: Best Marine, Arvada, CO.
- Clean out extra wires, broken guages, switches, etc.
- Activate: tach with new harness, volt meter, fuel gauge, temp, speedo at helm(using GPS on chartplotter).
- Activate: nav lights, anchor, deck and cabin lights.
- Activate: electric windshield wiper.
- Install dual battery switch and two batteries at port aft.
- Remove old bimini track, replace with longer new chrome track, sliders, and end caps.
- Install new 14" wiper blade.
- Protect seat cushion corners and edges with fabric or plastic tabs.
- Clean old silicone off rub rails. Re Seal with new Silicone bead.
- Patch gel coat dings on hull.
- Seal deck hatches.
- Purchase, install chartplotter, sonar, side scan transducers, wiring, and mounting bracket.
- Install under gunnel, LED lighting, and wire to helm switch.
To Do:
- Epoxy repair teak wood rod holder that got broken during electronics renovation.
- Treat teak trim with Teak Oil.
- Remove, clean, reseal/bed tow hook on bow.
No comments:
Post a Comment